FACTORIO BALANCER HOW TO
FACTORIO BALANCER FULL

I have also come up with a method to design many-to-many balancers, but the designs produced are too large to be of practical use.Д«ear in mind that the following information is merely the conclusions I have reached from my own investigation I do not have answers to some of the questions raised, and there is always the possibility that I am wrong about something. I have come up with a reliable method to design one-to-many splitters and many-to-one mergers.

FACTORIO BALANCER HOW TO

In it, I explain some of the theory behind how belt balancers work and how to design them properly. This вЂњguideвЂќ is the sum total of my belt-balancing knowledge after approximately 15 hours of research, testing and investigation. There are plenty of copy-and-paste designs on the wiki, but nobody seems to be explaining why they work, or how to make them yourself. When more than the number of allowed outputs backs up, the universal balancer behaves like a normal balancer, and may not balance properly.I have created what I call 'A compilation of research and occasionally a useful guide' on the designing of belt balancers, as this is a complex topic that I have recently been doing a lot of research into, and there seems to currently be a dearth of guides available. A throughput limited universal balancer may only have the capacity for a few unused outputs. If a universal balancer is throughput limited, the bottleneck may be in the loops or the balancer itself. Universal balancers can be throughput limited. These balancers can balance evenly between any inputs and any outputs. Universal balancers solve this issue by having the back-looping built in. Sometimes this can be fixed by looping the unused output back around the balancer and distributing it among the inputs. In essence this means that an n-n balancer is not a functional n-(n-1) balancer. Many balancers fail to balance properly once an output backs up or if an output is not used. This formula is based on the number of nodes in a BeneЕЎ network, which is essentially the same as a throughput unlimited balancer - it allows any input to reach any output. For n в†’ n balancers where n is a power of two numbers, nГ—log 2(n)в€’nГ·2 can be used to calculate how many splitters are needed. This is the case because they use more splitters than the minimum required amount of splitters for a throughput unlimited balancer. The resulting balancer is usually larger than a balancer that was initially designed to be throughput unlimited.

FACTORIO BALANCER FULL

A guaranteed method to achieve throughput unlimited balancers is to place two balancers back to back that fulfil the first condition for throughput unlimited balancers (100% throughput under full load). However most balancers' bottlenecks can't be solved as easily. This is done by adding two more splitters at the end of the balancer, as it can be seen here: In this particular case, the bottleneck can be fixed by feeding the two middle output belts with more splitters. So, if only one side of that splitter gets input, as can be seen in the gif, it can only output one belt even though the side of the splitter is fed by a splitters which gets two full belts of input. The bottleneck in this balancer is that the two middle belts only get input from one splitter. The gif on the right shows a 4 в†’ 4 balancer being fed by two belts, but only outputting one belt which means that its throughput in that arrangement is 50%. Any arbitrary amount of input belts should be able to go to any arbitrary amount of output belts.Д«alancers often do not fulfill the second condition because of internal bottlenecks.To be throughput unlimited, a balancer must fulfil the following conditions: Balancers that are throughput limited may not be able to provide maximum output if one or more outputs are blocked.

Factorio balancer